Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

How i connect OSC with XC9572

Thread starter J_expoler1
Start date Apr 29, 2003

Status: Not open for further replies.

Apr 29, 2003

#1

J

J_expoler1

Newbie level 6

CPLD XC9572 must config Xtal ?
pls advice me
thanks

May 6, 2003

#2

papyaki

Advanced Member level 2

The better is to use an oscillator connected to one of the GCK pins.

Status: Not open for further replies.

Similar threads

A
How can I run verilog code with data at a specific time in the past?
- Started by alexis57
- Jan 28, 2024
- Replies: 2
PLD, SPLD, GAL, CPLD, FPGA Design
M
How do I assign decimal values in verilog?
- Started by mahesh_namboodiri
- Jan 31, 2024
- Replies: 2
PLD, SPLD, GAL, CPLD, FPGA Design
S
synplify issue with xci import
- Started by skyworld_cy
- Feb 7, 2024
- Replies: 3
PLD, SPLD, GAL, CPLD, FPGA Design
T
Connect Microblaze to AXI4-Lite
- Started by trungnd33
- Mar 23, 2023
- Replies: 3
PLD, SPLD, GAL, CPLD, FPGA Design
M
How to connect AXI_LITE port of QSPI_FLASH to the RISC-V processor.
- Started by michaelScott
- Dec 31, 2022
- Replies: 0
PLD, SPLD, GAL, CPLD, FPGA Design

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.

Accept Learn more…

Top