Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

how to draw triangle in HFSS?

Status
Not open for further replies.

geppei

Junior Member level 3
Joined
Apr 20, 2006
Messages
31
Helped
0
Reputation
0
Reaction score
1
Trophy points
1,286
Activity points
1,489
hfss equation based surface

Could anybody know it?


Thx
 

equation based surface hfss

Salam

I have used the HFSS, though not much. Still I am learning about it. According to my experience you can not draw the triangle it self. But if you want to make some conical shape that is possible. As in the case of horn antenna just it is matter of conecting the surfaces.

Regards
Asim
 

how to draw trapezoid in hfss

just go >draw>line and draw a triangle formed
by three lines but make sure you close the
surface. If the surface is not cover go to
>3Dmodeler>surface>cover faces....
 

triangle hfss

you can also use equation to draw a triangle.

Draw-> equation based surface

or
Draw-> equation based curves.

Based on my view of points, the latter is more accurate than the first.
 

draw triangle in hfss

its simple u can use coordinate entry method and draw triangle and then fill the enclosed area
 

hfss draw triangle

double click after you have drawn 3 points and 2 lien segments.
 

formula to draw triangle

Use Draw line to form trangle or any other geometry in 2D. Then Select the object, copy it and paste to get a duplicate. Now use move to position for the desired thickness. Then select the two oblects (Control + click), from the menu select 3D Modeller > Surface > connect to get the 3D model.
 
Status
Not open for further replies.

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top