Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

New C_S_T Microwave studio 4.2 and Design studio 2.2

Status
Not open for further replies.

dainis

Advanced Member level 4
Joined
May 15, 2001
Messages
1,125
Helped
53
Reputation
106
Reaction score
9
Trophy points
1,318
Activity points
9,269
Released new updates ...
Anybody have positive experience of using these updates ?
 

Anybody no not have positive experience of using these updates ??? :(
 

hi dainis!
dainis said:
Released new updates ...
Anybody have positive experience of using these updates ?
when i've used mws v4.0 and v4.1 i wasn't able to optimize because of crashing in sbe6_32.dll (under winXPsp1). these crashes occured at some dimension variables modifications.
in mws v4.2 sbe6_32.dll is version 6.4.0.75 now (instead of 6.4.0.25) and i have no sbe6 errors.
mws works fine now! and i can use cst ds.
but i have cst ds v2.0 and i think it has some bugs.
parameter sweep works correct but i cann't understand what cst ds does during optimization. it reports goal is reached (|s11| dB < some value in some frequency range) but i can see that s11 value is greater than initial one. (??)
i hope new version is free from this bug.
best regards.
u_f_o
 

i must add ...

hi all there!
have you nice weekend!

i've forgotten to mention maybe most main.
some small cst bug :) :)
cst mws v4.x creates registry key:
[HKLM\SOFTWARE\CST GmbH\CST MicroWave Studio\4.0]
"INSTALLPATH"="your installation path"
but cst ds v2.0 looks for key:
[HKLM\SOFTWARE\CST GmbH\CST MicroWaveStudio\4.0]
"INSTALLPATH"="your installation path"
cst ds cann't find needed key, cann't run mws and creates error message:
"You have not installed Microwave Studio properly" or some similar.
suggested solving:
run regedit.exe and edit (better create new) CST GmbH key without whitespace between "MicroWave" and "Studio".
maybe this bug is absent in cst ds v2.2 ... regrettably i have not this version. :(

best regards.
u_f_o
 

Status
Not open for further replies.

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top