Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

[Question]Gate Oxide breakdown

Status
Not open for further replies.

OMEsystem

Advanced Member level 4
Joined
Dec 1, 2005
Messages
102
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,296
Activity points
2,061
If the device breakdown voltage is limited within 1.8V. That means
if the Vg-Vs, and Vg-Vd >1.8V, the gate oxide will be in breakdown.
My question is do we need to care Vg-Vsub, the gate-substrate voltage? Is it ok if
the Gate-Sub voltage is higher than breakdown voltage?
 

Status
Not open for further replies.

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top