Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

[help HFSS] What this error message means?

Status
Not open for further replies.
E

enyxep

Newbie level 4
Joined
Apr 20, 2006
Messages
7
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,281
Location
nottingham
Activity points
1,348
hi, i just run my simulation but it end up with this message:

[error] Port refinement, process abc3d : There are no tetrahedral faces assigned to boundary "Short". Since boundary operations are order dependent, please check to make certain that this boundary is not being ignored because of other operations on the same surface. It is recommended that you redefine the boundary in question.

does anyone knoe wut this means?
cheers,

enyxep
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top