Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

unbuffered Micron DDR2 model

Status
Not open for further replies.
C

chipart

Newbie level 1
Joined
Feb 24, 2006
Messages
1
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,281
Activity points
1,288
ddr2 model

Hi,

I need to set up a simulation with Micron unbuffered DDR2 SDRAM model.
Can someone tell me how I can tell if a micron part is unbuffered, registered
or fully buffered? This DDR2 would be used along FPGA, so unbuffered seems
to be the one.

Does it matter to simulate unbuffered or registered model for timing analysis
purposes? I assume som timing would be different.

Thanks,

--
:D
 

micron ddr model

Um, of course it makes a difference. Why don't you start by reading the device's datasheet. It's on the same page as the link to the verilog model you found at www.micron.com.
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top