Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

Can you manual change coordinates in WG2002 Symbol Editor?

Status
Not open for further replies.
J

Jayson

Full Member level 4
Joined
Oct 8, 2001
Messages
234
Helped
14
Reputation
28
Reaction score
5
Trophy points
1,298
Location
Brazil
Activity points
2,421
WG2002 Symbol Editor

Is it possible in WG2002 in the Design Capture Symbol Editor to manually change coordinates for something like a line, if I draw a line that will be part of the symbol and it starts at X=0 Y=0 and ends at X=10 Y = 0, is it possible for me to manual change such numbers so the line would end at say X=12.5 Y=0.1?

-Jayson
 

Re: WG2002 Symbol Editor

Jayson said:
Is it possible in WG2002 in the Design Capture Symbol Editor to manually change coordinates for something like a line, if I draw a line that will be part of the symbol and it starts at X=0 Y=0 and ends at X=10 Y = 0, is it possible for me to manual change such numbers so the line would end at say X=12.5 Y=0.1?

-Jayson
Click to expand...
************************************
yes

just click on the line ,make you grid, and move any part of the object !
or you can move ORIGIN !
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top