Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

How to program Xilinx 4000 series?

Status
Not open for further replies.

lollobrigido

Full Member level 2
Joined
Dec 13, 2002
Messages
134
Helped
2
Reputation
4
Reaction score
5
Trophy points
1,298
Location
Italy
Activity points
1,025
xilinx 4000

I need to develope with Xilinx 4000 fpga series (I have some pieces), but i don't have any developement system. Can someone help me?
The downloadable SW from xilinx doesn't porgram such devices!

Thx
Lollo
 

xilinx 4000 series fpgas

you need or the old foundatione series F3.1-3.3 or the full ise 4.x.
The XC4000 are the old top fpga of xilinx.
bye
 

fpga 4000 series from xilinx

Hi

I had recently the same problem with old Spartan.

There is a partial solution on Xilinx web. Browse deeply
on their site about "Classic" and you'l find a special free
ISE 4 for 4000 and Spartan.

The soft is named "spartan4k.exe", here is the link :

h**p://www.xilinx.com/webpack/classics/spartan_4k/index.htm

You must add third party sofwares for simulation and synthesis.

Good luck !
 

xilink 4000

maybe that you can only place and route the lowers members of this family.
I don't now whic is you r target device
Generally if you nedd to p&R over a 20.000 gates is inibhit.
 

Status
Not open for further replies.

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top