Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

drive a stepper motor

Status
Not open for further replies.

Jo_Jo

Newbie level 5
Joined
Jul 26, 2005
Messages
9
Helped
1
Reputation
2
Reaction score
1
Trophy points
1,283
Activity points
1,422
Hi all, remember me?
I drove a stepper motor with four phases and six wires by SLA7062, it can move now, but what should I do then.
I change the speed of motor by changing the frequency of CLK.
 

what do you mean by what else ?
to control a stepper motor , you either :
1- control mode of operation which may give ya higher accuracy in steps.
2- control speed of motor.
what's your application anyways ?!
 

    Jo_Jo

    Points: 2
    Helpful Answer Positive Rating
Stepper motors are mainly intended for position control applications without feedback. Try to rotate the motor to a specific postion then hold it in position. Perhaps you can despense with the LA and dirctly get the signals from a micorcontroller.

Good Luck
 

    Jo_Jo

    Points: 2
    Helpful Answer Positive Rating
I have finished that project. now workers are making 10 samples to test. I am so happy that I finished it befor 2006. thanks a lot,Ahmed Ragab & amrstaha.
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top