Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

Help PSPICE "No Pspice template ERROR"

Status
Not open for further replies.
S

sanjay

Full Member level 1
Joined
Jul 4, 2003
Messages
98
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,286
Activity points
1,012
Hi...

Can anyone provide me help..
I am trying to simulate a basic circuit non-inverting amplifier (using opamp OPA627 lib), but after having constructed the cct, when I try to simulate, I get the following message as Error in my Session Log saying

"No Pspice Template for U3, ignoring".. where U3 is the opamp I am using...
To check, if I get the same message with normal opamp lib, I just replaced the opamp with 741, and found no errors at all during simulation

As a result of this, I am unable to simulate..it with opa627 opamp :-(

Can anyone provide help

Regards
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top