Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

Can anyone advise using 89c2051 to build a count-up counter

Status
Not open for further replies.
L

landrover

Newbie level 3
Joined
Aug 14, 2005
Messages
4
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,281
Activity points
1,316
+89c2051 +bascom

I am a new starter from Hong Kong, self-learning 89c2051 for 3 months,now can use simple BASCOM programme to programe 89c2051,it is great.
i want to build a 3-digits 0-999 count-up counter with
using 89c2051 to drive 3 common anode 7-digits LED.
When input=high, it adds 1 up.
Pls advise circuit and .hex file.
Thanks.
 

Re: Can anyone advise using 89c2051 to build a count-up coun

hi landrover,
you could use one 8 bit port of the 2051 to connect to the pins of the seven segment display. Use three pins of the other port to select the 3 displays. Now your program should do this:
enable display 1. Send corr. digit to port one(connected to 7 seg).
enable display 2. Send corr. digit to port one(connected to 7 seg).
enable display 3. Send corr. digit to port one(connected to 7 seg).
do this quickly. prabably at 1-10khz so that the flickering would not actually be noticeable.
best of luck,
bye
 

Re: Can anyone advise using 89c2051 to build a count-up coun

Dear Kitaabs

Thanks for yr reply. i am a amateur, starting by learning other programe
could you advise where i can get the programe or hex file
Thanks
 

Re: Can anyone advise using 89c2051 to build a count-up coun

For someone who starts experimenting with 2051 this is a good site to visit:
**broken link removed**
(driving 7-segment + keypad ++++)
Regards,
IanP
 

Re: Can anyone advise using 89c2051 to build a count-up coun

THX
I WILL STUDY IT CAREFULLY
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top