Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

HFSS error after changing the material to aluminium

Status
Not open for further replies.

cvenkat

Full Member level 1
Joined
Jun 8, 2005
Messages
96
Helped
4
Reputation
8
Reaction score
3
Trophy points
1,288
Activity points
2,065
hi,
I simulated a structure with PEC as material. When I change the material to aluminum HFSS gives " Port refinement, process abc3d died unexpectedly"....can any one help me on this?
thanx in advance
cv
 

Re: HFSS error ....

the problem was probably due to the fact that hfss uses denser meshes for othe metals apart from pec. if the aluminium layer is thick, then, the meshing will be more. So the refinement process will also be complex. Try reducing the mesh refinement accuracy. it may help
 

Re: HFSS error ....

Also try to reduce the mesh resolution and check if the frequency you have specified matches to the geometry.
 

Status
Not open for further replies.

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top