Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Stator position in block commutation

Status
Not open for further replies.

electronicsman

Full Member level 5
Joined
May 4, 2012
Messages
291
Helped
11
Reputation
22
Reaction score
12
Trophy points
1,298
Activity points
3,737
I am bit confused with this, when doing 120 degree switching we know the rotor position by hall position which can have from 1 to 6. But how are we defining stator position? Yes it is fixed. But when we are saying the maximum angle between rotor and stator is 120 and minimum is 60 degrees. Whether stator is also measured in terms of hall table? Please advise.
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top