T
treez
Guest
Hello,
The following two opamp circuits (schematic attached) are exactly the same except for the fact that one has a 5V single supply and the other has a +/-5V dual supply. They both have the same shape of input signal which is also shown attached.
The opamps are LT1013's
LT1013 datasheet:
http://cds.linear.com/docs/en/datasheet/10134fe.pdf
If the circuit is made on a PCB, will the outputs be exactly the same for each of the circuits?
LTspice simulation also attached but it is not thought that it will be completely accurate
The following two opamp circuits (schematic attached) are exactly the same except for the fact that one has a 5V single supply and the other has a +/-5V dual supply. They both have the same shape of input signal which is also shown attached.
The opamps are LT1013's
LT1013 datasheet:
http://cds.linear.com/docs/en/datasheet/10134fe.pdf
If the circuit is made on a PCB, will the outputs be exactly the same for each of the circuits?
LTspice simulation also attached but it is not thought that it will be completely accurate
Attachments
Last edited by a moderator: