Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

Run BLE app at powerup IAR Workbench cc2650

Status
Not open for further replies.
W

winro

Newbie level 1
Joined
Nov 14, 2017
Messages
1
Helped
0
Reputation
0
Reaction score
0
Trophy points
1
Activity points
12
Hi,
I’m working with IAR Embedded Workbench IDE running the BLE simple_peripheral example on a cc2650 chip using a XDS110 Debug Probe.
Everything works fine, if I flash the stack with Project>>download>>download active application and then run the app in debug mode with Project>>download and debug. It jumps to main() and when I hit run it works.
I want the application also to run without the debug probe. Shouldn’t the main() run on start up if I use the Project>>download>>download active for the stack and the app?
I have set the -r parameter for the flash loader to retain the flash

Hope anyone of you is familiar with IAR and can help me out
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top