Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

Latching Relay vs FlipFlop Circuit

Status
Not open for further replies.
Hi Klaus,

There is no public datasheet or information, i would happily publish but i cannot. Its a one off module used for racing engines. For designing sake just say 100mA then. I am struggling with the electronics logic as you can clearly see.

Thanks,

Rocketman46
 

Hi,

Now 100mA without additional information, It doesn't make things better.

I really don't know:
* is your load connected to VCC, to GND or somewhere else.
* is your load purely resistive or complex
* is your load a logic input or are you trying to switch a supply voltage

A logic input is defined with: VIH_, I_IH, V_IL, I_IL .... this is what you need to find out what curcuit you need. It's not that I need it..

Klaus
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top