Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

How to make a 4 pin tactile switch schematic in proteus?

Status
Not open for further replies.

monauwarislam

Newbie level 1
Joined
Nov 5, 2017
Messages
1
Helped
0
Reputation
0
Reaction score
0
Trophy points
1
Activity points
9
There are several switch schematics in library of proteus but it is hard to build the tactile switch as given in the reference datasheet. I need to assign the footprint package to the schematic that has 4 pins but all I found was a DPST. Still this is not an effective solution to assigning packages, there should be a method to decompose the package and rebuild new prototype device wit similar properties. Any help would be deeply appreciated. 442865263_894.jpg
 

Status
Not open for further replies.

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top