Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

[SOLVED] Proteus Ir2112 problem

Status
Not open for further replies.

zaky.dzulfikri

Newbie level 1
Joined
Sep 13, 2017
Messages
1
Helped
0
Reputation
0
Reaction score
0
Trophy points
1
Activity points
7
Hi all..
I tried to built half bridge using 2 irf540 mosfets and ir2110 as gate driver, but due to unavailability of ir2110 in proteus so I replaced it with 2112 instead, but the problem is that the HO doesnt respond any input in HIN, and any PWM input would just be ignored. I curious what is the problem with that and I hope you can give me solutions
Capture.JPG
 

Hi,

A mosfet is controlled ON/OFF with it's Vgs.
Vgs means voltage between gate and source.

Therefore the driver IC need both these connections: gate and source of the Mosfet.
But you only connected gate to the driver.
--> connect mosfet_source to driver_Vs

This also is urgent for the bootstrap capacitor to be charged.

****
In real word your circuit will destroy itself. The motor is an inductive load, when the Mosfet is being switched OFF this generates high voltage spikes, killing the Mosfet.
--> use a free wheeling diode across the motor.

***
Dismiss R2. Or make it 100k, if you think you need it.
***
In a half bridge configuration D2 makes no sense.

Klaus
 

Status
Not open for further replies.

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top