Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

final steps to produce GDSII file for fabrication

Status
Not open for further replies.
Z

zyadzezo

Junior Member level 1
Joined
May 13, 2016
Messages
17
Helped
0
Reputation
0
Reaction score
0
Trophy points
1
Activity points
127
Dear all,

I hope you are doing well.

for first time i am implement layout with pex and lvs and DRC checks,now i want to put pads and continue fabrication process till tape out but i dont know anything about this steps,any recommendation any vedios any references i will appreciate your efforts.
i am working on umc130nm technology
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top