Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
You can configure amplitude and phase in the "setup solver" (go to simulation tab, click on setup solver)
In the setup solver, change source type to "selection" so that you can customize the stimulation.
Next click on the excitation list, to configure your excitations. Under excitation settings choose sequential or simultaneous. Now you can change the amplitude and phase shift of each signal.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
