Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

bending of structure on cst2011

Status
Not open for further replies.

prateek3790

Full Member level 2
Joined
Feb 8, 2016
Messages
131
Helped
1
Reputation
2
Reaction score
1
Trophy points
18
Activity points
1,190
i am drawing one self grounding bow-tie antenna, in the paper which i am following has a bending structure, since i am using HFSS 2008i am unable to do so. Is it possible to do the above thing in cst2011 also since i am using windows 10 will it support it.

there document says it doesn't, but just want to check whether someone is using it. also is there any other version of hfss or cst which will work on windows 10 and allows bending of structure.
 

Status
Not open for further replies.

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top