Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Eagle pro: Dual opamp naming as U3A and U3B

Status
Not open for further replies.
T

treez

Guest
Hello,
Please tell how to do this?
I am getting "U3G$1" and "U3G$2".

What i wish for is "U3A" and "U3B"

Do you know how to get this?
 

Did you try the RENAME command? That usually works for me.
 
  • Like
Reactions: treez

    T

    Points: 2
    Helpful Answer Positive Rating
Thanks, yes i tried it...but you can rename the "U3" bit, but you cant make the "G$1" bit to be "A"
 

Hi,

Open Library -->select device --> symbol --> NAME "A" --> click on the first symbol --> NAME "B" --> click kn the second symbol --> save library

Klaus
 
  • Like
Reactions: treez

    T

    Points: 2
    Helpful Answer Positive Rating
I believe that your DEVICE isn't set up properly for those. Right-click on the part and select DEVICE. Make sure that the A and B designate the individual parts like below. If they are still G$1 and G$2 then that is your problem.

 
  • Like
Reactions: treez

    T

    Points: 2
    Helpful Answer Positive Rating
Status
Not open for further replies.

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top