Enzy
Advanced Member level 1
I have seen a couple clip light circuits online and tested them out and they don't seem to work, what I had in mind was to build a simple circuit with just 2 leds one to show signal and the other for when the signal is clipping I have seen that on amplifiers but the circuits aren't really easy to find online.
I have been checking out some opamp videos as far as I see a voltage follower circuit with a diode and a cap at the output can be used as a clip light detector not sure if it is practical though.
- - - Updated - - -
That's a sketch of what I had in mind
I have been checking out some opamp videos as far as I see a voltage follower circuit with a diode and a cap at the output can be used as a clip light detector not sure if it is practical though.
- - - Updated - - -
That's a sketch of what I had in mind