Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Automating Momentum using Command Line

Status
Not open for further replies.

goay

Newbie level 5
Joined
Jan 9, 2017
Messages
8
Helped
0
Reputation
0
Reaction score
0
Trophy points
1
Activity points
80
Good day, recently I've done sumulation using ADS command line to automate circuit simulator. My command line looks like this:

[status,cmdout] = dos(['hpeesofsim C:\Users\USM-POSTGRADE\Documents\MATLAB\ADS\',netListFileName]);

which I did using MATLAB. However, I did not find any document regarding how to set up automating process for momentum. Can anyone help me? My ADS version is older than 2011 hence doesn't have access to ADS knowledge center. Thanks.
 

Status
Not open for further replies.

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top