Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

strange switch's arp table

Status
Not open for further replies.

julian403

Full Member level 5
Joined
Feb 28, 2014
Messages
254
Helped
1
Reputation
2
Reaction score
1
Trophy points
18
Location
Argentina
Activity points
2,105
Hello All.

Looking if there is a equipmente connected to a switch, in this case I was looking a nomadix I foud this table.

Capture.PNG

As the Switch is a 2-layer all that it's connected to it is in the same network so Why there is equipment with difference ip?

Ok, looking the network diagram there is a mikrotik router connected to that switch you can see that it's the 10.141.152.2 (you can see that the MAC vendor is routerboard) and there is a modem there, too. which make as a gateway.

The Switch match all ip that "pass through" his ports? or just the ip that are connected to it? in this last case why there is two difference networks

Thanks and regards.
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top