Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

Help me identify this connector Service Manual might be needed LG PA75U

Status
Not open for further replies.
N

ngen33r

Newbie level 6
Joined
Jul 9, 2017
Messages
12
Helped
0
Reputation
0
Reaction score
0
Trophy points
1
Activity points
127
This is a 12 pin connector 2mm pitch. Only marking I could find is YH.

Part number might be in the service manual. P100 is the location on the PCB

1314404570506.jpg
 

Last night I found the short that caused this. A 10uF SMD cap was fully shorted. Not sure how the cap outlasted the wires but the problem is solved none the less. Now I just need to rebuild the wire harness and It should be back in service, if I can find the parts.
 

Is it a one or double row type?
Did you checked i.e. Molex or JST & Binder types?
 
Last edited:

I checked both Molex and JST cant seem to find a match single row 12 pin
 

I was able to identify the connector on the opposite side of the cable. So I can now make 50% of the replacement cable. The 12 pin still eludes me.

Molex Pico-SPOX 1.5mm pitch.
87439-0800

The service manual does not list the part numbers for either the plug or the socket. So it is down to hunting for the match.
 

Here is another picture of the bad connector. Is there also anywhere else that I could post this to get more eyes to see it?

20170725_073526.jpg
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top