Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
You have actually got two errors there -- one about not finding the matching subcircuit in the file, as ErikL noted, and one about cannot read source. I suspect the second error can help you figure out why the subcircuit match was not found.
To find out which source is not being read, take a look at the LVS REPORT file. Assuming the 2011 interface is the same as the 2017 interface, the file name is in the Calibre Interactive - nmLVS window, in the Reports/SVDB tab (Outputs pane). It should be in the directory you started Virtuoso in. The report is pretty detailed, and described in the Calibre Verification User's Manual (calbr_ver_user.pdf) in the "LVS Results" chapter.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.