Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

EVAL-AD5933 Connector info for Impedance measurement

Status
Not open for further replies.

pavans2510

Member level 2
Joined
Jul 25, 2011
Messages
45
Helped
7
Reputation
14
Reaction score
6
Trophy points
1,288
Location
Bangalore
Activity points
1,562
Hi,
I am working on prototype for Complex impedance measurements and for this EVAL-AD5933 board from Analog Devices is being used.

1. Does any one know what is the type of connector is being used at Z for measurement? Highlighted in the below image

Connector.png

2. What are the factors that needs to considered for designing the cable for impedance measurement. Cable length required is 45 CM. Is there any ready cables available for this kind of interface/measurements?


Thanks in advance
 

Status
Not open for further replies.

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top