Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

executing file of ADS simulation

Status
Not open for further replies.

somaahamed

Newbie level 3
Joined
Jun 6, 2017
Messages
4
Helped
0
Reputation
0
Reaction score
0
Trophy points
1
Activity points
33
Hi
I would ask about executing file of ADS simulation. I mean if I design patch antenna at schematic and layout and do simulation. but I want to run the file in command prompt Ms-dos. how can I do it?

I hope find someone help me.


Thank you
 

What ADS version?

You can simulate a netlist from the command line, see online help "Home > Simulation > Simulation-Analog RF > Using Circuit Simulators", there is a paragraph "Running a Simulation from the Command Line"

I understand that you want to run a Momentum EM simulation from command line? Why?
 

Status
Not open for further replies.

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top