Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

CM and DM Impedance of 3 phase motor

Status
Not open for further replies.

GulraizAhmed

Newbie level 4
Joined
Jun 6, 2017
Messages
5
Helped
0
Reputation
0
Reaction score
0
Trophy points
1
Activity points
39
Hello,

I want to measure Differential mode and common mode Imoedance with Agilent Network analyzer. It has two ports.

For common mode i need to short circuit all phases and impedance between them and Body grouns is to be measured. For Differential mode 2 phases will be shorted and between these and other phase impedance to be measured,
as i am new to network analyzers I am confused how i can attach with Network analyzer as its has 2 ports and in each port there is one ground and positive terminal.

If i use only one port i have data of S11 parameter how i can get respective impedance out of it.

Help will be appreciated.
 
Last edited:

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top