Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

[SOLVED] PTM model card for low-power applications

Status
Not open for further replies.
{Width/Length} symbols are {W/L} (case insensitive). As they aren't found in the model card, these parameters are up to your choice (between upper/lower borders, limited by simulation accuracy) when you instantiate (call) the transistor.
 
Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top