Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Tek TDS2CM module repair question

Status
Not open for further replies.

ik1osg

Newbie level 1
Joined
Jun 20, 2017
Messages
1
Helped
0
Reputation
0
Reaction score
0
Trophy points
1
Activity points
8
Hi
-please apologize I'm new in forum-
I am trying to fix a TDS2CM module that hangs (blank screen at startup) my TDS scope. As a first attempt, I'd like to make sure that the firmware is still fine. I have read in quite old threads that .hex file can be found: I would like to try to burn a new eprom and see if this solves the problem.
The .hex file is wellcome...! :wink:
Any other advice is wellcome too!
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top