Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

How to work around with wrong PCB footprint?

Status
Not open for further replies.

dann11

Full Member level 3
Joined
Oct 22, 2015
Messages
166
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,296
Activity points
2,742
Hi! I have a PCB layout design which happens to have wrong footprints with few IC devices that were ordered. Like for example, TSOP-6 to SC88, SOT23 to SC-70, Can you please help me guys on how to work around on this error?
 

You can make PCB adapters that go from one package to another. A SC-70 might fit on a SOT23 footprint with a little help. Your other options are to order the parts in the correct footprint, or redo the board to reflect the different footprints.

This is why it is so important to double and triple check your work, taking all these things into account.
 
  • Like
Reactions: dann11

    V

    Points: 2
    Helpful Answer Positive Rating

    dann11

    Points: 2
    Helpful Answer Positive Rating
The PCB adapters are quite usefull for many cases, except if there are ICs dealing with high speed digital signals. or high resolution analog signals. Anyway, if you don't have a reasonable logistic/purchase support, whenever possible it is always a good measure to draw footprints in such a way that accepts more than just 1 package option.
 
  • Like
Reactions: dann11

    V

    Points: 2
    Helpful Answer Positive Rating

    dann11

    Points: 2
    Helpful Answer Positive Rating
just check the soldering feasibility with the PCB adapters as sometime they are difficult to solder on PCB with wrong footprint
 
  • Like
Reactions: dann11

    dann11

    Points: 2
    Helpful Answer Positive Rating
If the PCB is manufactured then the only way is to solve this problem is by soldering and by using adapters if available.
 

Status
Not open for further replies.

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top