+ Post New Thread
Results 1 to 3 of 3
  1. #1
    Full Member level 5
    Points: 4,033, Level: 14
    hm_fa_da's Avatar
    Join Date
    Sep 2003
    Posts
    258
    Helped
    10 / 10
    Points
    4,033
    Level
    14

    Using Electronic Fuses instead of Mechanical Fuses ?

    Hi,

    I'm designing a circuit which may be used in hazardous area which needs ATEX certification. there are some mechanical fuses which are almost expensive for usage inside the circuit, my board needs 2 fuses, one about 100mA and one about 3A for GSM.
    As ATEX certified fuses are expensive, about 4USD each, i thought of using Electronic Fuses instead of them, chips like ST STEF033 and other similar chips from TI or ...
    Do you see any problem in this plan ? i think electronic fuses can be better even ...

    Thanks & Regards,
    Hooman Falahati.

  2. #2
    Super Moderator
    Points: 234,858, Level: 100
    Awards:
    1st Helpful Member

    Join Date
    Jan 2008
    Location
    Bochum, Germany
    Posts
    40,581
    Helped
    12407 / 12407
    Points
    234,858
    Level
    100

    Re: Using Electronic Fuses instead of Mechanical Fuses ?

    Forget about it. Semiconductors are simply not considered reliable in the ATEX world.


    1 members found this post helpful.

  3. #3
    Advanced Member level 1
    Points: 5,561, Level: 17

    Join Date
    Feb 2002
    Location
    Italy
    Posts
    407
    Helped
    50 / 50
    Points
    5,561
    Level
    17

    Re: Using Electronic Fuses instead of Mechanical Fuses ?

    I fully agree with the previus answer; in atex word the rules are very strict due the thinking and experience made.
    Do not try to overtake the rules, you have no chance to pass the test.
    I.E. if a circuit is hort circuited, only the fuse guarantees that it will open.
    Do you will rely an alectronc circuit being surrounded by an explosive mixture ?


    1 members found this post helpful.

--[[ ]]--