Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

Litepoint IQview tester

Status
Not open for further replies.
A

arr_baobao

Full Member level 2
Joined
Nov 1, 2011
Messages
134
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,296
Activity points
2,317
Hi ,

I'm having problem with my litepoint IQview tester.
According to datasheet, what i need to do was just to launch any browser and type in the IP address of the IQview tester on the address tab which is 192.18.100.254 to get into the tester GUI. I failed to do so, cannot load the page and can't ping the device with the address.
I had make sure that i had my Ethernet cable connect to my labtop and iqview tester.
Anyone encounter this before. Did i miss out any step or configuration?

thanks

regards,
bao
 

I think it should be 192.168.xxx.xxx not 192.18.xxx.xxx
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top