Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

[SOLVED] Sub connection on BJT on ams35

Status
Not open for further replies.

Hesam2sh

Newbie level 3
Joined
Jun 1, 2017
Messages
3
Helped
0
Reputation
0
Reaction score
0
Trophy points
1
Activity points
20
Sub conncection on BJT on ams35

Hi dear colleagues
How can I connect sub lead of any bjt on ams35 pdk on cadence virtuso layout !!!!???
 

Re: Sub conncection on BJT on ams35

Substrate "tap" library elements, or a P+ contact nearby,
would be needed to pass DRC. But the substrate connection
happens all by itself in junction isolated P-handle CMOS, no
way around it. Everything that is not "something else", is
"substrate".

Now some PDKs do have neediness, like you have to put a
"bulk" polygon or some such thing before the extract rules
will work right. I haven't used this "ams35" kit, to say. But
a well done PDK should have such things documented,
either in the verification stuff, the layers descriptions, or
both. Again, though, I don't use this kit so can't say whether
it's "well done" either.
 
Re: Sub conncection on BJT on ams35

Substrate "tap" library elements, or a P+ contact nearby,
would be needed to pass DRC. But the substrate connection
happens all by itself in junction isolated P-handle CMOS, no
way around it. Everything that is not "something else", is
"substrate".

Now some PDKs do have neediness, like you have to put a
"bulk" polygon or some such thing before the extract rules
will work right. I haven't used this "ams35" kit, to say. But
a well done PDK should have such things documented,
either in the verification stuff, the layers descriptions, or
both. Again, though, I don't use this kit so can't say whether
it's "well done" either.

TNX for your attention

the PD_C contact solved the issue....
 

Status
Not open for further replies.

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top