Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

simulation results and post-translate results are different.

Status
Not open for further replies.
H

hcu

Advanced Member level 4
Joined
Feb 28, 2017
Messages
101
Helped
0
Reputation
0
Reaction score
0
Trophy points
16
Activity points
874
Hello,

I am on Ise, I got the results as per the requirement while simulating behavioural code, but after synthesis , while simulating the .ngc file (post translate). simulation results are not that expected. what are the options available to make them look same in both cases??
 

If you have simulation/synthesis mismatch, you might have either bad stimulus timing in your testbench or you have used bad coding practices and have a design that is functionally incorrect.

As you haven't show us any information that is the best answer I can give you.
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top