Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Help On Menu using switch

Status
Not open for further replies.

cnandha19

Member level 3
Member level 3
Joined
Aug 28, 2015
Messages
59
Helped
1
Reputation
2
Reaction score
1
Trophy points
8
Activity points
604
I want to go to sub menu is it correct way

1.Enter key pressed means it prints
1.ADMIN
2.Operator
3.Setter
In sub menu if '1' pressed it has to go to 1st menu (ADMIN) please help regarding this
if '2' pressed it has to go to 2nd menu (Setter)

Code:
        key  =READ_SWITCHES();
        switch(menu)
		{
			
			case mIdle:
			{
				
						
				switch (key)
				{
				 unsigned char ret ; 
				 case enterkeystore:
				 {
					 lcdClear();
					 lcdMoveCursor(0,0);
					 lcdPrintStr("1.ADMIN");
					 lcdMoveCursor(1,0);
					 lcdPrintStr("2.SETTER");
					 lcdMoveCursor(2,0);
					 lcdPrintStr("3.OPERATOR");
					 delay_s(1);
					 ret =READ_SWITCHES();
					 
					 if(ret == '1')
					 {
						 lcdClear();
						 lcdMoveCursor(1,0);
						 lcdPrintStr("ADMIN");
						 delay_s(1);
					 }

                                         if(ret == '2')
					 {
						 lcdClear();
						 lcdMoveCursor(1,0);
						 lcdPrintStr("SETTER");
						 delay_s(1);
					 }
					
				 }
				 break;
 

your code MAKES NO SENSE AT ALL.
Why are there so many variables ... Key, MiDle, enterkeystroke, ret ??

With Switch/ case/switch case all nested one inside the other ?
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top