Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Peak long and peak short currents

Status
Not open for further replies.

reddvoid

Junior Member level 3
Joined
Apr 8, 2013
Messages
27
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,281
Activity points
1,587
Hi,
Can somebody explain what are these parameters physically in a circuit.

PKS = Ipeak_short/Ipeak_short_limit , where duration for Ipeak_short is 125ps
PKL = Ipeak_long/Ipeak_long_limit , where duration for Ipeak_long is 100ns, or total simulation time (if simulation time is less than 100ns

Thanks
 

Hello,

What is the circuit about? schematics?
Which application?
Which simulation tool?
What is the context?
 

Hello,

What is the circuit about? schematics?
Which application?
Which simulation tool?
What is the context?


a standard cell circuit like level sifter, nands, adders etc
ansys totem for reliability validation
Reliability analysis, Electromigration, self heating, S factor, stuff like that
 
Last edited:

PKS = Ipeak_short/Ipeak_short_limit , where duration for Ipeak_short is 125ps
PKL = Ipeak_long/Ipeak_long_limit , where duration for Ipeak_long is 100ns, or total simulation time (if simulation time is less than 100ns
I guess these are different weighing parameters (As/s ?) for the calculation/estimation of electromigration damage, together with repetition frequency and wire width.
 

Status
Not open for further replies.

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top