Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

counter implementation in simulink

Status
Not open for further replies.

hanikapa

Member level 4
Joined
Feb 6, 2015
Messages
71
Helped
0
Reputation
0
Reaction score
0
Trophy points
6
Activity points
510
I have a counter design in simulink that is active with rising edge of the clock. I use enable port to activate the output when the pulse level is high and reset the counter to initial state. But in my design when the pulse level is low, counter keeps the previous state. Does anybody have an idea?
thanks
the continues value at the output of counter is related to the time that the pulse is low level. I want that this constant value be resetted to initial state of the counter.
count.png
 
Last edited:

You must add gain box , then double click to put parameters such as Maximum valve , Minimum valve ,... etc. Add this to loop by break th line in a point of loop.

Consult the book : Matlab Handbook , also.
 
Status
Not open for further replies.

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top