pcca
Junior Member level 3
Hello,
I am trying to perform some monte carlo runs in an low-voltage delta-sigma modulador using Hspice.
A verilogA script is used to save the output bitstream data in a txt file, for example 'bitstream.txt'.
I would like to know if it is possible to run monte carlo and save each monte carlo simulation in a file like: bitstrem_1.txt (for MC simulation 1), bitstream_2 (for MC simulation 2).
Is there any variable that I can use to do that?
Regards,
PCCA.
I am trying to perform some monte carlo runs in an low-voltage delta-sigma modulador using Hspice.
A verilogA script is used to save the output bitstream data in a txt file, for example 'bitstream.txt'.
I would like to know if it is possible to run monte carlo and save each monte carlo simulation in a file like: bitstrem_1.txt (for MC simulation 1), bitstream_2 (for MC simulation 2).
Is there any variable that I can use to do that?
Regards,
PCCA.