Enzy
Advanced Member level 1
I am designing a circuit and for some reason I am confused on how not to short the output.
at pin 3 of the 555 timer if I connect it to the gate of a N-Channel FET and the source of the fet to GND I dont think I could directly add a positive dc voltage to the drain of the FET since that would short out.
My aim is to gain a higher voltage and also to switch the higher voltage at high frequency, so would I have to add a coil in series with the drain of the fet then apply the positive dc to the coil?
at pin 3 of the 555 timer if I connect it to the gate of a N-Channel FET and the source of the fet to GND I dont think I could directly add a positive dc voltage to the drain of the FET since that would short out.
My aim is to gain a higher voltage and also to switch the higher voltage at high frequency, so would I have to add a coil in series with the drain of the fet then apply the positive dc to the coil?