Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

How to save data from transient simulation on ADE in cadence to use it in matlab?

Status
Not open for further replies.

sohaee

Junior Member level 2
Joined
May 28, 2016
Messages
20
Helped
1
Reputation
2
Reaction score
1
Trophy points
3
Activity points
153
Hi everyone!
I'm trying to run a transient simulation in cadence and plot the output, but after finishing the simulation, I can't plot any node and an error of "unable to allocate memory.." is shown. Now I want to save the data from simulation to use it in matlab and draw the plots there.
Does anyone know how to do this?

thank you so much!
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top