+ Post New Thread
Results 1 to 2 of 2
  1. #1
    Full Member level 5
    Points: 3,117, Level: 13
    Achievements:
    7 years registered

    Join Date
    Sep 2008
    Posts
    310
    Helped
    0 / 0
    Points
    3,117
    Level
    13

    Placement of the shielding material to the wireless power systems

    Hi All, I have a 13.56MHZ wireless power transfer system. In this system, there is also the data link operating at the other frequency.
    I was trying to use the flexible shielding material to minimize the noise coupling from the power coil to data coil. However, if I use the material to cover the power Rx coil, it will block the power transfer from Power Tx coil, and there is no power supply of the board.

    I am using the co-plane structure for the Rx coils. The picture is shown here.
    Click image for larger version. 

Name:	shield.jpg 
Views:	9 
Size:	145.6 KB 
ID:	138061
    The flexible shielding material (for 13.56MHz shield) comes from here http://katalog.we-online.de/en/pbs/WE-FSFS . Would anyone teach me where should I place the material? Thank you very much!

    •   Alt20th April 2017, 16:13

      advertising

        
       

  2. #2
    Member level 5
    Points: 1,145, Level: 7

    Join Date
    Jul 2014
    Location
    UCSD
    Posts
    90
    Helped
    25 / 25
    Points
    1,145
    Level
    7

    Re: Placement of the shielding material to the wireless power systems

    you want to set it up something like this I believe
    Click image for larger version. 

Name:	shield.jpg 
Views:	4 
Size:	152.0 KB 
ID:	138371

    Also make sure you tune your system with the shielding in the way, it will alter your coil L and Q.


    1 members found this post helpful.

--[[ ]]--