Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Ultrasonic MEMS microphone Receiver Amplifier/filter

Status
Not open for further replies.

Dino1400

Full Member level 1
Joined
Sep 22, 2010
Messages
95
Helped
2
Reputation
4
Reaction score
2
Trophy points
1,288
Activity points
1,941
Hello All,

I'm trying to design a Ultrasonic Receiver, I have used one of the comment circuit available online. I'm having an issue of swing; the output looks amplified but doesn't really swing rail to rail or at least around zero. I have attached the circuit and the simulations. I should be amplifying and and filtering ( center frequency 40KHz).

Thank you in advance


ultrasonic.PNG


ultrasonic1.PNG
 

hi,
You say its a 20kHz to40kHz BP filter, but your signal source is set to 4kHz.???
E
 

The second stage is a second order band pass filter has a center frequency of 20KHz and a band with of 26KHz.
 

hi,
Unless I am misreading your circuit, you are using a 4000Hz signal source.
This is well outside the pass band.??
E
 

Attachments

  • A004.gif
    A004.gif
    7.2 KB · Views: 85

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top