Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

HFSS 18.0 - Port refinement, process hf3d error: Too few conductors were found on por

Status
Not open for further replies.
F

fuzzybear3965

Newbie level 3
Joined
Apr 18, 2017
Messages
3
Helped
0
Reputation
0
Reaction score
0
Trophy points
1
Activity points
19
I am having a problem with my simulation: "Project1"
Project1_Simulation (Transient Network)
[error] Port refinement, process hf3d error: Too few conductors were found on port 1. There should be one conductor for each terminal, with one additional reference conductor. Unintentional contact between conductors may cause this error.. (9:38:07 PM Apr 17, 2017)"

I have confirmed that the two conductors defined on the port (ground plane and signal line) are not in contact.
 
Last edited by a moderator:

HFSS Tranisent solution: Port refinement, process hf3d error: Port '1' contacts more

I am an having a problem with an HFSS microstrip simulation: "Transient (Transient Network)
[error] Port refinement, process hf3d error: Port '1' contacts more than one non-conducting material which violates the TEM terminal modes restriction.."

My port, indeed, contacts both FR-4 and vacuum, but this doesn't seem to be an issue according to the documentation. Can anyone tell me how to avoid this?
 
Last edited by a moderator:

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top