Aaron_
Newbie level 1
Hello everyone,
I'm working on a small project of simulating a wireless transmitter and receiver. First of all I was unable to find HT12E/HT12D codec in the library of proteus so I created them following the steps from this video https://www.youtube.com/watch?v=-J2T35RfBA0&t=609s
After that I downloaded Modulo_RF.zip that contains the transceiver and the receiver.
and lastly after pressing the play button in the bottom to start the simulation nothing happens.
Can someone please pinpoint the problem
Here's a schematic of what I have done.
Also here's a downloadable link from the save
https://www.dropbox.com/s/v3hz44pceig3jwh/Project.pdsprj?dl=0
I'm working on a small project of simulating a wireless transmitter and receiver. First of all I was unable to find HT12E/HT12D codec in the library of proteus so I created them following the steps from this video https://www.youtube.com/watch?v=-J2T35RfBA0&t=609s
After that I downloaded Modulo_RF.zip that contains the transceiver and the receiver.
and lastly after pressing the play button in the bottom to start the simulation nothing happens.
Can someone please pinpoint the problem
Here's a schematic of what I have done.
Also here's a downloadable link from the save
https://www.dropbox.com/s/v3hz44pceig3jwh/Project.pdsprj?dl=0
