Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Cylindrical coordinate robot

Status
Not open for further replies.

nidahas

Junior Member level 2
Joined
Oct 4, 2007
Messages
20
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,281
Activity points
1,432
I am trying to make a cylindrical coordinate robot , with a grip (open and soft close functions) for 100 gr load. The arm is connected to a base that rotates 360 degrees. The arm moves as telescopic 0-10 cm, and up and down (Z
axis) 10 cm.
I am confused about my choice of motors...the more i read the more it becomes difficult for me to decide between servo and stepper with encoders.
and i am also shaky on calculating the torques .
kindly give your expert opinion.
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top