Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

[Moved]: Some problems about using Calibre LVS

Status
Not open for further replies.

PinTall

Newbie level 1
Joined
Jan 10, 2017
Messages
1
Helped
0
Reputation
0
Reaction score
0
Trophy points
1
Activity points
8
Hello everyone,


I have some problems when solving LVS.
There are my netlist, LVS report and layout.
11.jpg22.jpg33.jpg
It seems that my elements are not matched because they can't find in my schematic.
I check my layout and schematic, but I think that is all right and matched.
Are there still some problems I didn't find out?
 

Calibre LVS probably can't find the subcircuits for your cells. Make sure to include the correct subcircuit lib!
 

Check your device model definition. Some of it might be just a model instead of subcircuit. Subcircuit model = XM12. Model without subcircuit = MM12
 

Status
Not open for further replies.

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top