Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

15 Watt RF Power Amplifier Selection 140-170 MHz

Status
Not open for further replies.

adnan012

Advanced Member level 1
Joined
Oct 6, 2006
Messages
468
Helped
2
Reputation
4
Reaction score
2
Trophy points
1,298
Activity points
4,923
hi,

I want to make a amplifier simulation in ADS. How amplifiers are selected on out put power bases. Suppose i select AFT09MS015NT1. Can i get 15 watts 136--174 as mentioned in datasheet, If the amplifier is properly matched.

Regards
 

Hi,
It looks like you can squeeze 15W from this device at the required frequencies.
You should ask for S-parameters from the vendor and check stability and matching.
R.
 

Status
Not open for further replies.

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top